There are two types of modular formworks manufactured; steel surfaced modular formwork and plywood surfaced modular formwork.

Modular system formwork can be used by hand and if required, can be carried by a crane by mounting the panels each other. Thanks to the connection parts such as pins, shafts and levered locks, practical and useful formwork panels can be formed.

This is 60% economic compared to timber. .

Components with standard sizes are produced for external and internal corner curves. Adjustable corner components in different angles are produced except standard 90 corners.

Soldiers act as support and anchorage between two panels. They also act as carriers in escalating formwork. Since the anchorage with the counter formwork is carried out by means of holes over soldiers, drilling of panels is avoided.

The surface sheet of wedged panels is made of 3 mm thick sheet. There are wedge holes every 5 cm over edge borders, which are made of 3 mm sheet having 8 cm width. There are a couple of support stringcourses depending on the size of the panel. A swift mounting and demounting is ensured by making special production complied with the project.

The edge and middle sheets of pinned panel formworks are made of 5 mm thick and surface sheet is made of 3 mm thick. The edge borders are 6 cm in width and there are pin holes every 5 cm.